Radiator Flush and CLeaner Fuid
Autoblizz radiator flush and cleaner fluid is designed to clean the cooling system quickly and effectively. It clears blocked water channels that can cause overheating, removing rust and sludge. Use before changing coolant or adding antifreeze to help keep your cooling system in optimum condition.
How to use
- If the cleaner is concentrated dilute it. 1:15- 1: 20. Use a big container
- Next drain the radiator. Put a drainage pan or other container underneath the radiator’s drain cock opening.
- Take off the radiator’s top fill cap. Open the radiator’s bottom. Drain cock using pliers or gloves to empty the radiator.
- Put the liquid in the designated disposal replace the drain plug.
- Put cleaner in. slowly pour the cleaning solution into the radiator’s fill hole. For this a funnel will be helpful.
- Give the mixture 5 minutes to sit in the radiator.
Start the engine. To allow the cleaner to cycle through the lines, start the engine and let it run for 5 to 15 minutes. - Now drain the cleaning solution. Cut the engine off. Open the drain cock and let the cleaning solution drain.
- Reinstall the drain cock after that make sure to properly dispose off the used cleaner.
Rinse. Fill the radiator with water using pure distilled water. - After starting the engine let it idle for five minutes.
- After that shut off the engine and reopen the drain and let the water drain.
- Switch out the drain cock.
- Lastly add new coolant.
